9. Place the magnetic based discharge hose I nozzle assembly underneath the range hood, i.e., one magnet base in each side of the range hood routing the stainless steel braided hose around obstacles. Slack in the hose is permissible. Magnetic force will hold the discharge hose I nozzle assembly underneath the range hood. Refer to Pages 14 and 15 (FIGURE 23 & 24) for proper placement.
FIGURE 22
NOTE: The nozzle openings must be facing towards the stove top. Insure magnet bases are not in a cocked position, i.e., are not being held securely to the range hood.
Extend the stainless steel braided hose from the extinguisher cylinder assembly through the 7/8” hole. Hook the quick connect hose fitting to the discharge hose/nozzle assembly at the Tee Fitting.
10. Place sensor 1 metal housing against the side of the magnetic base of the nozzle assembly. Magnetic force will hold sensor housing to magnetic base. The sensor diodes must be facing towards the stove top with open side of sensor housing facing up and against the range hood. Carefully wrap the sensor wires around the braided hose while inserting through the 7/8" hole. Insure sensor housing I sensor diodes are parallel with the stove top, with sensor diodes facing the stove top and sensor housing is being held securely to the magnetic base, i.e., sensor housing is not in a cocked position. Position the magnetic nozzle I sensor base inside the exhaust hood, as referenced in FIGURE 22 and aim the nozzles, as outlined on Page 15 (FIGURE 25). |
 FIGURE 23
11. To place sensor 2 metal housing on the other magnetic based nozzle assembly, repeat procedure in step 10.
12. Hook up sensor wires according to FIGURE 3 Page 5. Use wire strain relief on enclosure circuit board frame to hold sensor wires in place.
|
HOME