Sonic Receiver Assembly (P/N G315-A)

DESCRIPTION:

NOTE: UL Listed “ONLY”

The optional Sonic Receiver Assembly will work with either any configuration of Electric Shutoff (P/N G319) or the Gas Shutoff (P/N G316-A). Some site conditions have difficulty installing the standard Interconnect Cable from the Main CPU control board.  For convenience and ease of installation, the Sonic Receiver Assembly provides a remote sonic activation. (See FIGURE 9 & 18)    

If the Sonic Receiver is affected by external interference from a site condition, the standard interface cable may need to be used.
(See FIGURE 1)

 See SONIC RECEIVER TEST PROCEDURES on Page 16 to electrically check out the optional Sonic Receiver Assembly.

FIGURE 9               Sonic Receiver
                                 (4” x 4” x 1.5”)`

Alarm / Strobe Assembly (P/N G320-A)

DESCRIPTION:

Both electric shutoff and gas shutoff provide interfacing a (120 volt-5A) alarm / strobe.  This assembly has a Plug & Play configuration for ease of installation.  Install in optimum location for visibility.  This feature is mainly used with the strobe function.

To electrically check out the Alarm / Strobe Assembly, plug in the assembly and perform the System Check Out on Page 16. See FIGURE 10 below.

FIGURE 9              Length of Cable
                                     96” (8 Ft.)

        Interface Enclosure Assembly (P/N G317-A)

DESCRIPTION:

The optional Interface Enclosure Assembly (P/N G317-A) is provided to allow easy interfacing to external devices i.e., automatic telephone dialers, monitored security alarm systems or other warning /protective equipment. The Interface Enclosure Assembly provides one set of dry contacts when connected with the Gas Shutoff (P/N G316-A) and two sets of dry contacts when connected to the Electric Shutoff.  Contact rating is 120 VAC 5 amps.  Verify that contacts switch during checkout procedures.  See Page 16 & 17 for check out procedures.  See FIGURE 11 below

FIGURE 11                 Length of Cable 18"