Guardian Model 1384-A Owner's / Installation Manual
Page 14
ACCESSORIES
Twenty First Century offers a complete line of optional accessories and shutoff devices listed for use with the Guardian Model 1384-A and 1384-ASH. (Assembly and wiring instructions are provided with each optional accessory.) Consult your TFC representative for current models available. For additional accessories see Addendum No. 71758-3 dated August 2000.
OPTIONAL AUDIBLE ALARM (P/N 21C/W3IT)
DESCRIPTION
Audible Alarm: 120-volt alarm to warn occupants when the Guardian is activated. (P/N 21C/W3IT)
A remote manual release system (manual pull station) is available where local fire codes or circumstances require the capability to manually activate the range top extinguisher system. Manual activation of the system will cause the extinguisher unit to fully discharge extinguishing agent, shut off the range top burners and activate an alarm or other electrical accessory. Once activated, the automatic sequence cannot be interrupted.
The manual pull station is installed at a height not exceeding 60" form the floor and should be located in the path of exit. Avoid locating the manual pull station where the occupant would have to reach over the range top cooking elements to activate the system. (Some jurisdictions require certain distances.) Only Manual Pull station (P/N 21C/ PULL R80015) shall be used.
FIGURE 20
INSTALLATION INSTRUCTIONS
NOTE: Before starting, reinstall safety pull pin in valve assembly (See Step 11 Procedures).
1. Determine the best location for the manual pull station box. The location must be accessible with a maximum of seven (7) additional corner pulleys and a maximum of twenty nine feet, seven inches (29' 7") of conduit. The manual pull station is usually located opposite the extinguisher kit. Adjust the extinguisher kit mounting accordingly - on the right or left side of the range hood (see Figure 22).
2. Attach a corner pulley to the rear corner pulley piping opposite the extinguisher kit. The manual release system cable will be an extension of the detection kit cable. The manual pull station replaces the cable nut.
3. Install conduit and additional corner pulleys as necessary to reach the manual pull station box. All cable must be fully enclosed in rigid conduit from the detection kit rear pulley to the manual pull station box (conduit must be provided by installer).
A looped end on the cable attaches to the S hook between the last link and rear corner pulley assembly. NOTE: Make sure both cable ends are crimped and all "S" hooks closed. Total length of conduit (all sections) must not exceed (29� � 7") feet. Total number of corner pulleys added to the detection kit must not exceed seven (7).
4. Remove the manual pull station cover plate and pulley assembly. Route the cable around the floating pulley and mount pulley assembly in the pull station box. Secure the cable end with the cable nut provided. (See Figure 20)
FIGURE 21
NOTE: See Installation Step 6 (Detection Kit Adjustments), Page 10 in this manual.
5. Insert the pull pin to lock the floating pulley in position before attaching the pull pin ring or replacing the cover plate. Adjust the cable length to properly align the fire detectors and tighten the cable nut allen set screw.
6. After the extinguisher system installation is complete and final adjustments have been made, replace the manual pull station cover plate, insert the pull ring into the pull pin and install the tamper seal (See Figure 21)
HOME
