EXTINGUISHER AND BRACKET KIT COMPONENTS
(P/N 1384A/CYL/CHARGED & 1384A/EXT/SUB)
FIGURE 2
|
DESCRIPTION:
The extinguisher kit consists of the pressurized storage cylinder for the chemical agent mounting bracket support assembly and other components identified with Figure 2.
LIMITATIONS:
The extinguisher cylinder shall be installed in locations where the temperature will range between 32 � F (0� C) and 120� F (49� C). Never attempt to use the fire extinguisher as a hand held portable extinguisher.
CAUTION: Serious injury could result from misuse.
THE CHEMICAL AGENT USED IN THE GUARDIAN IS NOT REGARDED AS A TOXIC MATERIAL, BUT CAN CAUSE IRRITATION IF BREATHED IN SUFFICIENTLY HIGH CONCENTRATIONS. AVOID CONTACT WITH SKIN OR EYES. IN CASE OF CONTACT, FLUSH IMMEDIATELY WITH WATER FOR 15 MINUTES. IF IRRITATION PERSISTS, CONTACT A PHYSICIAN IMMEDIATELY. CHEMICAL DEPOSITS ON ELECTRICAL CONTACTS CAN PREVENT OR REDUCE CONDUCTIVITY OF THE CONTACTS. ELECTRICAL POWER MUST BE SHUT OFF PRIOR TO TOUCHING ELECTRICAL APPLIANCES SPRAYED WITH THE CHEMICAL. |
 |
PARTS LIST |
|
| DESCRIPTION |
QTY |
| |
|
1-Series 'A" Mounting Bracket
(P/N 34018-SW) |
1 |
2-Mechanical Electrical Switch
(P/N PCLCD-2A) |
1 |
3-Series "A" Extinguisher Cylinder
(P/N A0515-S) |
1 |
4-UL Label
(P/N UL1 384-A) |
1 |
5-Series "A" Valve Assembly
(P/N A7022-S) |
1 |
6-Tension Spring
(P/N 48410) |
1 |
7-Handle Extension
(P/N 21C/DRY/HDL- EXT) |
1 |
8-Pull Pin, Ring Type
(P/N A16235) |
1 |
9-Cable Tension Adjuster
(P/N 48888) |
1 |
10-Flare Adaptor 3/8" X 5/8"
(P/N 57500) |
1 |
11-Pressure Gauge
(P/N G303/C) |
1 |
12-90� Pressure Elbow 90� X 1/8"
(P/N1202 P2-2) |
1 |
3-Cylinder Band
(P/N 21C/1384A/30175) |
1 |
14- Wheel Bearing Pulley 1
(P/N 21C/ /KB9O1) |
1 |
| |
|
|
page 4 of 16
previous <<
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
>> next
|
HOME