TOOLS REQUIRED FOR SYSTEM INSTALLATION

3. Remove all components from box and familiarize yourself with assembly components.

4. Measure out 4-1/4" from the side wall inside floor of your cabinet and 1" from the rear back inside floor of your cabinet. (The Guardian Ill is usually installed on the left side however, right side mounting is an option.) (See FIGURE 17).

5. Where the points cross mark for drilling. Drill required (7/8") hole through cabinet floor and range hood, being careful to avoid obstacles or wiring underneath the range hood.

6. Carefully remove top cover of the enclosure - set cover to the side. (See FIGURE 2)

7. Center the enclosure base complete with cylinder over the pre-drilled hole. The 1" hole in the enclosure base should be aligned with the 7/8" hole just drilled.

8. Fasten enclosure base in place through screw holes located in rear top and front corners of enclosure base. Screws are provided with system. Fasten the base plate first in front of the unit; back plate last being careful not to bend bracket back towards the wall.

INSTALLATION INSTRUCTIONS

Before beginning installation of your Guardian Ill unit, locate and identify each part. (See FIGURE 1). Turn off the circuit breaker to the kitchen range hood and stove before boring holes. Wear approved safety goggles. Protect stove top surface from falling debris.

MINIMUM AND MAXIMUM HEIGHTS OF HOOD, NOZZLE TIPS AND SENSORS FROM TOP OF THE BURNERS